## Model/Introduction/Purpose This is my first introduction into the world of injection molding. I've been thinking about ways to increase the speed of production for some small, simple plastic parts. This might help ### Current Mods None. ### History Purchased components August of 2025. ### Planned Mods I am planning to redesign the acrylic panels so that I may cut them using my [[Carvera Air]]. I'm also going to attach them with [FT Panel Clips](https://www.printables.com/model/869312-ft-panel-clips-for-2020-extrusions) ### Current State Frame assembled ### Build Log #### 2025-10-10 Started to build the frame today. I got to page ten in [the manual](https://drive.google.com/file/d/1zg0rRujJQF1wtNAtguwyY8d_fwCQzAzu/view). The frame is just about complete. | | | | | -------------------------------------------------------------- | -------------------------------------------------------------- | --------------------------------------------------------------- | | ![[PXL_20251010_220538941.RAW-02.ORIGINAL.jpg\|Page 2]] Page 2 | ![[PXL_20251010_222108396.RAW-02.ORIGINAL.jpg\|Page 3]] Page 3 | ![[PXL_20251010_222916408.RAW-02.ORIGINAL.jpg\|Page 4]] Page 4 | | ![[PXL_20251010_223702717.RAW-02.ORIGINAL.jpg\|Page 5]]Page 5 | ![[PXL_20251010_223840375.RAW-02.ORIGINAL.jpg\|Page 6]]Page 6 | ![[PXL_20251010_224543439.RAW-02.ORIGINAL.jpg\|Page 7]]Page 7 | | ![[PXL_20251010_230059456.RAW-02.ORIGINAL.jpg\|Page 8]]Page 8 | ![[PXL_20251010_230617641.RAW-02.ORIGINAL.jpg\|Page 9]]Page 9 | ![[PXL_20251010_234715112.RAW-02.ORIGINAL.jpg\|Page 10]]Page 10 | ![[Discussions]]